This example sequence is an introduction into calling the Public API of multiple DQMH modules from TestStand. This example starts a Thermal Chamber Controller DQMH module (singleton) and a single instance of the Device Under Test DQMH Module (cloneable) and executes the following sequence:

  1. Update the Set Point, Ramp Rate and Heater State (to allow heating).
  2. Monitor the status until the target Set Point is reached.
  3. Perform a simulated self-test of the DUT.

To get the example:

  1. Go to Help>Find Examples
  2. On the NI Example Finder window, select Directory Structure>Delacor>Delacor QMH>DQMH Fundamentals – Thermal Chamber.
  3. Open DQMH Fundamentals – Thermal Chamber.lvproj.
  4. Open Thermal Chamber Controller Example With DUT.seq.

See LabVIEW Example 2: Thermal Chamber Controller with DUT.vi for a similar example in LabVIEW.